ASTRO-PHYSICS V2 ASCOM DRIVER DOWNLOAD

You can create a PE correction curve immediately after acquiring data or use the log file created in a previous session. AstroPhysics V2 Setup v5. Any other suggestions will be appreciated. It is the mount that is being controlled. If you have Ask for Filename and Comments when Acquiring Data checked in the Settings menu, you will have a final opportunity to add comments to the file or delete the log file and start over. In most cases you won’t need to do any modifications to the curve.

Uploader: Gukus
Date Added: 23 March 2013
File Size: 66.65 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 4738
Price: Free* [*Free Regsitration Required]

I must give it a go.

Click Stop when you are done collecting data. Read and display the mount’s PEC table. At an earlier date, it was recommended on the ASCOM site that you NOT uninstall earlier versions, but that recommendation has now been removed, and is apparently no longer valid. Select your camera control program and connect to your CCD camera by pressing the Connect Camera button.

Astro-Physics V2 ASCOM Driver and Tutorial Videos

PEMPro is automatically synchronized to the mount. This is a major upgrade from Platform 4. The table will then fill with entries from the file and a graph of the curve will display.

Set the COM port. Adjust a PEC curve before sending it to the asgro-physics.

Note that while you can still use Park 1, do so at your own risk. You will be presented with one final opportunity to enable or disable the mount’s PEC mechanism.

ASCOM and the Astro-Physics ASCOM V2 Driver

Most advanced planetarium and telescope control software packages have an option to use the ASCOM platform, or else they require it outright. In either case it is best to pick a star within 45 degrees of the celestial equator in Northern hemisphere: I’ve just resigned to park it from the hand controller.

Park 4 and Park 5 have the advantages of Park 1 sscom. With PEMPro you can: I had the same problem. They are not from an Astro-Physics mount.

It will not work with earlier platforms. After each worm cycle the color of the data will change.

They are all Rev G or later. Here is a summary of all of astro-hysics controls: Make sure that you are connected to the mount and the CCD camera as described above. Smooth – Does a very modest smoothing of the curve.

In most cases you won’t need to do any modifications to the curve. After making adjustments to a PEC curve with any of the above buttons you will need to write it to the mount with the To Mount button. This allows you the freedom to move the mount around without worry of forgetting to re-synchronize. The mount’s periodic error should be significantly reduced. You can create awtro-physics PE correction curve immediately after acquiring data or use the log file created in a previous session.

Any advice or clues would be most welcome. Please use one of these versions if you are in Europe and have “,” and “. Save a PEC curve to a file. If you are upgrading from version v5. You do not need to uninstall a previously version version of the driver, even if you want to install an older version over the top of a newer version.

It is not actually lost, it was astro-phyzics incorrectly initialized. Not sure about Park 2 because I haven’t used it.